Coltuk.org
http://www.coltuk.org/phpbb3/

Wheel stud replacement
http://www.coltuk.org/phpbb3/viewtopic.php?f=21&t=28729
Page 1 of 1

Author:  Coltchris [ February 6th, 2017, 6:37 pm ]
Post subject:  Wheel stud replacement

Looking for some advise on wheel stud replacement on my colt cz2 after damaging one removing my locking nut after going down a pot hole a wrecking the alloy wheel. Is it case that they just pop/knock out after removing the break disk or is there more to it that this! Any help greatly appreciated.

Author:  FishYWishY [ February 6th, 2017, 7:26 pm ]
Post subject:  Re: Wheel stud replacement

They will pop out. Easiest way I found is to put a nut on the bolt (make sure the bolt isn't protruding from the nut if you ever need to use it again) and whack is squarely with a decent size hammer. To fit, push in and gently tap on the back, once you have the wheel on and tightening the nuts, it will seat itself fully.

Author:  Coltchris [ February 6th, 2017, 8:50 pm ]
Post subject:  Re: Wheel stud replacement

Thanks, should hopefully be a quick fix then

Author:  FishYWishY [ February 7th, 2017, 7:11 pm ]
Post subject:  Re: Wheel stud replacement

Yeah, doesn't take long! :winkthumb

Page 1 of 1 All times are UTC [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/